Commander using Squad Leader arty point

[slyder73]

I have searched far and wide on these forums and not found an answer so here is my question.

As a Commander/Team Leader, I can call arty on any spot I designate. This works fine.

Squad leaders can also designate spots on the Team Leader's map for arty call. I cannot figure out how to switch from my own Commander target to squad leader target to call arty.

When several arty targets are marked on the Commander map at the same time, how do I select the one I want the arty to fall on?

 

[I. Kant]

Click it with the mouse pointer?

 

[Rrralphster]

It's quite fidgitty. As if the mousepointer is misaligned, but it definately works.
Hold the mouse pointer over the icon and move the pointer a bit.
It will turn orange. When orange click it.

 

[boogada]

Yeah, watch for the color change and then click. Don't click too much though, they sometimes get removed.

 

[slyder73]

Thanks. I'll have to try that. I did make an attempt to mouse over the target and select it but the mouse wasn't aligned with the target correctly and the switch to the orange colour did not remain. It goes back to green for me and the Commander arty always has precedence over the SL arty.

 

[HorniHornsen]

did i get this right: the orange marker is where the shells will go down? or the green one?