[Error] MG 34 belt clips through receiver

[Zaltehook]

Found a small graphical error with the positioning of the belt on both the level 50 MG 34 and the stationary MG 34s.

While aiming down the sights of a level 50 MG 34 using an un-zoomed FOV of 90 degrees the ammo belt "pops" up and out of the receiver. The same will happen when manning a stationary MG on a tripod. While zoomed in the belt is shown properly feeding on the left side.

On another note, the reload animation for the belt fed MG is a bit off. The player models hands are out of sync with the belt being placed, the hands move significantly faster than the belt.

[Camskies]

I've seen the reload animation for both MGs be way out of sync with the player model. Their hands move in a way that doesn't hold onto the new mag when putting it in. It looks funny but I hope tw addresses this.

Also I've seen the bipod on MGs remain undeployed while using cover, I'm not sure if anybody has spoken about it I've only start on the forums today :P